Andrew Watson: I started this site to post helpful tips from all areas of my expertise and Find thewindow that is most accessible and ... 3 Step 3: Test Run1. his comment is here No more error light for the Toner Posted by solj at 10:40 6 Responses to "False toner light on Brother HL-2140" Bill Dorsey says: April 10, 2013 at 18:10 Rather

After clearing the jam as per Brother's instructions the jams keep happening. Brother Hl 2140 Toner Light Stays On Press the GO button 2 times. Close cover.

I covered both with electrical tape and presto it worked!!

I took the three screws out of the cartridge and removed the gears to colour in the window on the opposite side of the cartridge. Recently, it now jam every paper. Hers are $16 each! How To Bypass 'toner Life End' On Brother After following your steps, the toner light went off, but it wouldn't print.

Thnx!!

I have the Brother MFC-7340 printer and when I tried colouring in just the accessible glass window I received the same error message. It took tape over the sensor, but it got me through the event! An unfortunate "feature" of this software is that if it thinks you are low on toner, you have no choice but to replace the toner before it will let you print. http://krokmel.com/brother-hl/brother-toner-error-hl-2140.php The toner level sensor port is on the right side of where the toner sits in the machine.

Take out the toner cartridge.2. Did have to turn power off after completing and then on again, but then it was smooth sailing. just type hl-2140 - unknown 0 how to solve this problem??? Why would we waste toner while there's still inks left? [email protected]#$% these printer companies.

All of the LEDs will turn off. I was in the middle of working an event where I needed to print 100 pages of invoices for people. My printer started working. Liste de vidéos à visionnerFile d'attenteListe de vidéos à visionnerFile d'attente Tout supprimerDissocier Chargement… Liste de vidéos à visionner File d'attente __count__/__total__ Brother HL-2140 Toner pkok3 S'abonnerAbonnéAnnuler160160 Chargement… Chargement… Opération en

Turn the printer off. 3. slo says: this printer is terrible. Brother HL-2140 - Reset Drum After changing a DR2100 drum unit in a Brother HL-2140, the printer’s page count needs to be reset. Thank you for spending some time to visit our blog.

If done correctly, when you plug your printer to your computer it should try to reinstall the drivers under Brother Maintenance Mode. It worked. 🙂 It seems that every time a toner needs to be replaced this needs to be done. 3D Showcase 3D Showcase / Flashforge Creator Pro / Tinkercad Tinkercad Drinks Options: Reply• Quote Re: Brother HL-2140 toner light stays on after toner was replaced in cartridge Posted by: Dennis S Date: November 16, 2010 02:32PM I bought only toner, not a If you cover that with something that doesnt let light in (i used cardboard from a 12 pack of beer) then you wont get that error anymore and you'll print happily